VIC9060 — VIC Laser Cutting Machine

For the VIC9060 working area, compare the complete 900*600mm rectangle with your layout. The neighboring entries change both dimensions: VIC6040 gives 600*400mm, while VIC1390 gives 1300*900mm. Include the outside size of the starting blank in your comparison, even when the finished parts are much smaller.

The published VIC structure combines a CO2 cutting head and tube with linear guides, stepper motors and belt drive. Use those descriptions as headings in a configuration comparison. If a supplier offers a specific component version, keep its identification with the model and selected power so that later revisions can be checked against the same list.

The table labels Cutting Speed as 150mm/s. It does not provide a cutting time for a particular drawing. If cycle time matters to your purchase, submit the material, thickness, geometry and intended quantity as a separate requirement for discussion. A single catalog speed cannot answer all of those job-specific questions.

Suppose you are deciding whether one recurring blank size belongs on the 900*600mm shortlist or needs the 1300*900mm model. Send the blank dimensions with a drawing of the intended arrangement. Mark which dimension is fixed by your incoming material and which dimensions describe the final pieces; otherwise a review can start from the wrong outline.

Give the drawing a revision reference and explain what you need from the finished work. Identify any dimensions that matter to the next operation. Where several materials or thicknesses are under consideration, list them separately and ask for configuration advice for each. These are purchasing inputs, not a claim that every proposed combination has already been validated.

VIC9060 uses the shared Ruida control-system entry with USB interface. PLT, DXF, BMP, JPG and AI appear among the listed graphic formats. Supply a representative production file as well as the visible drawing, and identify its units and revision in your inquiry. The listed file names alone do not describe the contents of your job.

The worktable choice is Knife Table or Honeycomb Table. The VIC configuration describes an aluminum blade worktable for the knife option. State which table you want assessed for the intended work and ask for the offered selection to be written into the proposal. Keep any alternative clearly identified.

An optional red-dot pointer projects a visible point for material positioning. It can be requested with the table and selected laser power. Also provide the electrical supply at the installation address: the published alternatives are 220V/50HZ and 110V/60HZ. Have the proposed electrical version identified before comparing the final equipment lists.